Computer-Aided Design, Engineering, and Manufacturing

Скачать в pdf «Computer-Aided Design, Engineering, and Manufacturing»




COMPUTER-AIDED DESIGN, ENGINEERING, AND MANUFACTURING SYSTEMS TECHNIQUES AND APPLICATIONS


VOLUME V


the DESIGN oF MANUFACTURING SYSTEMS


2001 by CRC Press LLC


COMPUTER-AIDED DESIGN, ENGINEERING, AND MANUFACTURING


SYSTEMS TECHNIQUES AND APPLICATIONS

the DESIGN of MANUFACTURING SYSTEMS


EDITOR


CORNELIUS LEONDES

CRC Press


Boca Raton London New York Washington, D.C.


Library of Congress Cataloging-in-Publication Data



Catalog record is available from the Library of Congress.


This book contains information obtained from authentic and highly regarded sources. Reprinted material is quoted with permission, and sources are indicated. A wide variety of references are listed. Reasonable efforts have been made to publish reliable data and information, but the author and the publisher cannot assume responsibility for the validity of all materials or for the consequences of their use.


Neither this book nor any part may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying, microfilming, and recording, or by any information storage or retrieval system, without prior permission in writing from the publisher.


The consent of CRC Press LLC does not extend to copying for general distribution, for promotion, for creating new works, or for resale. Specific permission must be obtained in writing from CRC Press LLC for such copying.


Direct all inquiries to CRC Press LLC, 2000 N.W. Corporate Blvd., Boca Raton, Florida 33431.


Trademark Notice: Product or corporate names may be trademarks or registered trademarks, and are used only for identification and explanation, without intent to infringe.

Скачать в pdf «Computer-Aided Design, Engineering, and Manufacturing»